We're so confident of our products that we provide no hassle product exchange.
Nutanix Certified Professional - Business Continuity (NCP-BC) 7.5 Sample Questions:
1. What must the maximum Round Trip Latency be less than between a Witness VM and Metro Availability PDs?
A) 5ms
B) 200ms
C) 500ms
D) 100ms
2. An administrator is testing the failover scenarios from a source availability zone (AZ1) to a destination availability zone (AZ2). The administrator successfully performs an unplanned failover from AZ1 to AZ2.
The administrator then immediately tries to use the unplanned failover option to fail the VM back to AZ1, but does not see the VM listed under Recovery Plan. What could be the cause?
A) Clean up of Entities is needed to perform failback.
B) Replication is not yet successful from AZ2 to AZ1.
C) Recovery Plan is not bi-directional.
D) Unplanned failover cannot be used to failback VMs.
3. Which two Data Protection technologies are compatible with Self-Service Restore? (Choose two.)
A) Volume Group manual snapshot
B) Async replication schedules
C) Nearsync hourly recovery points
D) Synchronous data replication
4. An administrator performs these steps while configuring Nutanix Disaster Recovery:
* Create VMs on Site A in a container named SalesA
* Create a new container on Site B named SalesB
* Create new Protection Policy name Async
* Place all the new Sales VMs in the Protection Policy named Async
* Set a schedule to begin taking hourly snapshots immediately
After performing the steps, replications begin without any errors. After two hours, the administrator checks on the progress on the remote site and finds that the SalesB container is showing 0 bytes.
What went wrong?
A) The Sales VMs are unsupported for replications.
B) The same name must be used at both sites.
C) Advanced Replication add-on license isn ' t applied.
D) The schedule is a Nearsync schedule.
5. An administrator is validating a newly created Recovery Plan and receives the following warning:
IP addresses xxx.xxx.xxx.xxx cannot be preserved/mapped for VM REPORTVM01.
IP addresses cannot be preserved/mapped for entities
IP might be already in use or will be used by some other VM for recovery. IP cannot be mapped.
Only one IP address can be preserved for a vNIC in an IP address management enabled network.
What can the administrator do to resolve this warning without changing the existing IP address assigned to the VM?
A) Disable IPAM on the recovery site subnet to allow Nutanix DR to preserve static IP addresses during failover.
B) Remove and re-add the VM to the Recovery Plan to trigger a fresh IP address mapping validation.
C) Add an additional vNIC to the VM and assign the IP address to the new vNIC to bypass the IPAM conflict.
D) Configure Custom VM IP Mapping in the Recovery Plan to define explicit IP address mapping for the VM.
Solutions:
| Question # 1 Answer: B | Question # 2 Answer: A | Question # 3 Answer: B | Question # 4 Answer: B | Question # 5 Answer: D |
By Montague
