CWNP Certified Wireless Analysis Professional Sample Questions:
1. What element was added to the general frame of 802.11 with the 802.11e amendment and the 802.11-2007 rollup?
A) HT Control
B) Address 4
C) RSN-IE
D) QoS Control
2. You are using a laptop-based protocol analyzer to scan all channels and determine the basic configuration of the WLAN Basic Service Set in your facility. You are scanning all channels. All configured with default settings.
What can you change to cause the scan to run faster while still APs are capturing beacon frames on all the channels?
A) Configure the scan time for channels to <100 ms
B) Configure the scan time for channels to 300-500 ms
C) Configure the RBW to more than 120 kHz
D) Configure the fragmentation threshold to 1500 bytes
3. You are tasked with describing the various frames used in 802.11 communications.
What frame is used for spectrum management, fast BSS transition and some other actions taken within a BSA?
A) CTS
B) Action
C) PS Poll
D) BlockAck
4. You are using a Wireless Aggregator utility to combine multiple packet captures. One capture exists for each of channels 1, 6 and 11.
What kind of troubleshooting are you likely performing with such a tool?
A) Fast secure roaming problems.
B) Narrowband DoS attack detection.
C) Interference source location.
D) Wireless adapter failure analysis.
5. HOTSPOT
A manager at a retail outlet has complained that an incident occurred allowing a STA to launch an attack against another STA connected to their public Wi-Fi hotspot. He has asked you to troubleshoot the situation and verify that all possible measured are being taken to prevent this.
What configuration should you check in the AP?
Solutions:
| Question # 1 Answer: D | Question # 2 Answer: C | Question # 3 Answer: B | Question # 4 Answer: C | Question # 5 Answer: Only visible for members |
We're so confident of our products that we provide no hassle product exchange.


By Will

